For loader tires out of the question, will directly lead to can't continue to work effectively, and can only continue to change after work, so efficient and fast change the opinions of the tire is very critical for us, let's take a look at how people are replacement tires.
Loader for immediate replacement tyres 9 footwork you know
1 to start the machine, nearby to find a relatively flat, open ground, pressure movable arm lifting lever, using movable arm supporting the front wheel off the ground, and then with a brace in the side of the bridge near the flat tire, and the rear wheel wedge good (must be in close coordination with the driver, so as not to cause personal injury).
2 using the crow, and so on tool, remove the retaining ring and lock ring and then check tyre liner and rim surface adhesion (tires to use for a long time, padding and rim surface adhesion) can occur. In case of adhesion, can remove the machine in short run slowly to and fro, until the pad away from the external surface of the rim. It is strictly prohibited to and high speed, so as not to damage the inner tube. Then, the front wheel support.
And tyre within three to the relative position of tag, in order to search, removal and repair of tyres.
4 using tools, such as the crowbar from the tire on the rim will be removed. Note that action should be to gently with the tacit understanding, to avoid being injured by tire parts, and to protect the valve.
5 tues nails slender foreign body after the injury, if no obvious smaller wounds or wound surface, moreover tire may continue to use the (because loader tire belongs to low pressure and speed is slow); If wound is bigger, it must be repaired (because the machine is running, the tyre by extrusion friction, a long time will damage the inner tube, even wound is more and more big, the projection of the inner tube caused tire scrap).
6 if new inner tube, the bolt at the bottom of the valve must be tight, in case of gas leakage; Then put the tyre inner cavity of the foreign body removal, and then into the appropriate talcum powder, apply evenly. In order to make the pad and the inner and outer cover against, should give appropriate inflatable inner tube after into the inner tube, and set packing.
7 will be loaded on the rim tires, locking ring, ring; The installation process to protect the valve.
8 with vehicle air compressor to the tyre.
9 pressure movable arm lifting lever, remove the bracket; At this point in finished, the entire process takes about 50 min. After the tires, you need another loader or other auxiliary lifting equipment, tire after will support and other procedures are the same as the front tires.
二手挖掘机
popular types：Caterpillar Komatsu Hitachi
