Hooray Machinery Co.,Ltd
hot keywords: Used Excavator Used Grader Used Bulldozer Used Loader

How to reduce the drivers tracks wear

Creation:HOORAY Source:Hooray Machinery Release Time:2016-10-25 21:51

Abstract:小松液压挖掘机电控操纵系统控制原理
It is well known that walking part of the excavator is mainly by the driving wheel, chain wheel, roller and track link, etc.Essential to each homework can control operation, therefore, when running after a certain amount of time, these parts will appear different degree of wear and tear.Real momo are here to share some daily maintenance methods, can reduce the excavator crawler wear and avoid the failure in the future still need to spend a lot of time and energy to repair.
The first point: when not working because of malfunction of roller is found, should be repaired immediately.
If there are part of chain wheel or roller is no way to continue to work, continue to use in such conditions, is likely to cause the roller grinding partial, and may even lead to wear track link.So when encountering the situation such roller can't operation, be sure to repair immediately, such ability can avoid other fault in time.
The second point: as far as possible avoid excavator in sloping ground or swerve.
Long walking, suddenly turned on sloping ground, repeatedly side leads to track link and driving wheel, guide wheel on the side of the place, resulting in increased the degree of wear and tear.So, as far as possible choose straight line and in the process of operation, can effectively prevent the excessive wear.
The third point: regular inspection, reinforcement bolt, nut, which can effectively reduce the track abrasion.
Roller, the installation of driving wheel of crawler plate bolts, bolt, walking piping, etc., due to the equipment to work long hours, it's easy to loose because of vibration.If the crawler plate bolts loose cases continue to operate the equipment and may create a gap between the bolt and crawler board, which can lead to crack of segments.And clearance may also increase the result of track and track link between bolt hole, cause there's no way to tighten, causes the consequences of the track and track link must be replaced.
Although cause excavator crawler wear are a few small details, but it is these small details, such as do not pay attention to is likely to lead to big faults and consequences.Real momo hope everybody JiaYou can share experiences, learning to improve maintenance skills, cherish and protect our revolution good brothers.
上一篇:没有了 下一篇:To buy Used excavators must see Backtrack

Home About Us Product Center Used Excavator Used Loader Used Grader Used Bulldozer Road Roller Cases Contact Us

all right reserved © Hooray machinery Co., Ltd Copyright 2014 - 2016 All Rights Reserved Unauthorized copying is prohibited website map
Tel(WhatsApp)+0086-17721063468 +0086-17765155439 +0086-17717579778  QQ: E-mail:fiona@hooraymachinery.com/ catherine@hooraymachinery.com/
Hooray Machinery Co.,Ltd Address:No.5182 South Hongmei Road,Minhang District,Shanghai,China